BSJ Banner Series

Banner Installation Guide

Special Concerns:
As with any retractable banner stand, never release the banner from a raised position. Always hand raise and
lower the banner. Damage to unit or banner may occur if the banner is released from a raised position.



Locate the top banner rail and included allen wrench. Loosen the screws on the top of the banner rail.
Remove the adhesive strip inside and peel off the backing.



Tape the top of your banner to the adhesive strip and then return it back to the inside of the banner rail.



Remove the adhesive backing on the leader coming out of the base.
Tape the bottom of your banner to the leader. Note: We recommend adding more adhesive strips
to make sure that your banner is securely attached to the leader.



While holding the top of your banner securely, remove the pin from the side of the base.
Do not pull the pin out until your banner is completely installed.
This is what gives your banner tension, and once you pull the pin out there is no way to re-tension your banner stand.
Slowly guide the banner into the base.



Slide over the piece of black plastic that holds the pole inside of the base. Lift and raise the pole.



Raise the banner and attach it to the top of the pole.



Attach the light to the top of the pole.