TSBNQB Banner Replacement

This process requires no tools and will take approximately 10-20 minutes.

In order to replace your banner, you will a need clear, clean surface that is wide enough to fit your banner stand and is at least 3ft long. A conference table or floor works well.

Removing the Old Banner


1. Release the banner from the top rail friction grip.
Do this by lifting and separating the opposite side that the banner attaches.
You may need assistance for this as it is may be difficult to open.
Using tools is not suggested as it may damage the rail.

2. Repeat this process for the bottom rail friction grip.

3. The old banner should now be free from the system.
Installing the New Banner


1. Locate the top and front of your new banner.
With the banner and top rail facing the same direction, insert the banner into the top rail.


2. With the banner fully inserted into the top rail close the friction grip to secure the banner.

3. Repeat this process for the bottom banner rail.

4. Setup your banner as normal